Bb-electronics Celeron M Universal Network Controller with PC/104 Uživatelský manuál stáhnout pdf (Strana 24)

Chapter 3 Initial Setup

3.1 Inserting a CompactFlash Card

The procedure for installing

a CompactFlash™ card into the UNO-2170

is detailed below,

please

follow these steps

carefully.

Remove the

power cord.

Unscrew the four

screws from

the

rear panel

of the UNO-2170.

Remove the

rear panel.

Plug

a CompactFlash™ card

with

your

OS and application program

into a CompactFlash™ card slot

on board.

Screw

back the rear

panel with four screws.

Note

The CompactFlash™ slot

is allocated as

“

Secondary IDE Master

＂

3.2 Chassis Grounding

The aluminum made UNO-2170 provides good EMI protection and a stable

grounding base.

There is

easy-to-connect

chassis grounding point for

you to use.

Please connect

chassis ground of

UNO-2170 with "EARTH" as ground.

Figure 3.1:

Chassis Grounding Connection

UNO-2170 User Manual 18

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 39 40

UNO-2170 1
User Manual 1
Contents 5
Overview 7
Chapter 1 Overview 8
1.2 Hardware Specifications 9
1.3 Safety Precautions 10
1.4 Chassis Dimensions 11
Hardware Functionality 13
2.1 Introduction 14
Mode Selection 17
2.3.7 IRQ and Address Setting 18
2.7 USB Connector 19
2.5 Power Connector 19
2.8 PCMCIA: PC Card Slot 20
2.9 VGA Display Connector 20
2.10 Battery Backup SRAM 21
2.11 Reset Button 21
Initial Setup 23
Chapter 3 Initial Setup 24
3.3 Connecting Power 25
3.4 Installing a Hard Disk 25
System Settings and 27
Pin Assignments 27
Assignments 28
Table A.3: 31
Connectors and Jumpers 31
A.9 VGA Display Connector 35
Programming the 37
Watchdog Timer 37
Timer function 38

Komentáře k této Příručce

Žádné komentáře

Bb-electronics Celeron M Universal Network Controller with PC/104 Uživatelský manuál Strana 24

Komentáře k této Příručce

Související produkty a manuály pro Hardware Bb-electronics Celeron M Universal Network Controller with PC/104